# Chair-Side Whitening

> Questions for dental practices about chair-side whitening with PAP: procedure, duration, delegation to the practice team, equipment, enamel and comparison with hydrogen peroxide.

### How does a chair-side treatment work?

The Chair-Side Whitening System with 13% PAP consists of a gel and a whitening activator. The two components are mixed directly before use. This is how the treatment works:

1. **Shade assessment:** You determine the starting shade together with your patient.
2. **Gingival protection:** The gums are covered with cotton rolls and a gingival barrier.
3. **Mixing and applying:** For each cycle, you open one gel pot, add the activator, mix both and apply the gel to the teeth.
4. **Exposure and suction:** The gel works for 15 minutes and is then removed with a suction cannula. You repeat this cycle four times in total.
5. **Finish:** You rinse the oral cavity with water, remove the gingival barrier and cotton rolls and determine the tooth shade again.

Detailed instructions for use are included with the system.

### How long does a treatment take?

The treatment takes place in one session. The gel works in four cycles of 15 minutes each, so 60 minutes in total. On top of this come the shade assessment at the start and end, and placing and removing the gingival barrier.

No impressions, no lab work and no follow-up appointment are needed. The treatment therefore fits easily into your existing appointments, for example directly after a dental hygiene session.

### Who can carry out the treatment?

The protocol is simple and can be fully delegated to your practice team. The treatment can be carried out by dentists, dental hygienists or prophylaxis assistants.

Before whitening, you check as usual that the teeth and gums are healthy. Your team can then carry out the treatment independently, without an extra training day.

### Does the practice need special equipment or a whitening lamp?

No. You do not need a whitening lamp or any new equipment. The gel works without light.

Everything else is already available in your practice: cotton rolls for gingival protection, a suction cannula to remove the gel and water for rinsing. Because the protocol is so simple, you can delegate the treatment to your prophylaxis team.

### Does PAP whitening damage enamel?

No. In independent laboratory tests, including at Empa (Swiss Federal Laboratories for Materials Science and Technology), the enamel showed the following after treatment with our technology:

- **Surface:** no erosive changes.
- **Roughness:** no significant increase compared with untreated enamel.
- **Surface hardness:** only negligible changes.

In the same tests, a product with 40% hydrogen peroxide changed the surface morphology, significantly increased roughness and reduced hardness near the surface.

The reason lies in the mode of action: PAP oxidises the colour molecules primarily at the enamel surface and penetrates much less deeply. The technology has also been studied by the Fraunhofer Institute.

### How does the result compare with high-strength hydrogen peroxide?

With PAP, your patients achieve a natural white. In laboratory tests, our technology effectively whitened enamel samples, compared with conventional in-office products with hydrogen peroxide.

The difference lies in how they work:

- **High-strength hydrogen peroxide** penetrates through the enamel and dentin to close to the pulp. This allows very strong whitening but often leads to temporary hypersensitivity.
- **PAP** works primarily at the enamel surface. Sensitivity therefore occurs much less often.

For very deep, stubborn stains, hydrogen peroxide can be the stronger option. For this, we offer our Whitening Trays with 6% hydrogen peroxide for use at home.

---
Canonical: https://www.alpinewhite.com/en-CH/faq/chair-side-whitening
