# Effective whitening, *gentle treatment*

> An effective alternative to high-concentration hydrogen peroxide – gentle on enamel and pulp, and scientifically grounded.

## Whitening with *regulatory certainty*

Since the EU MDR, the legal situation for bleaching products containing more than 6% hydrogen peroxide has been unclear. Some manufacturers have withdrawn their products from the market, leaving practices without planning certainty.

ALPINE WHITE's patented technology offers an effective and gentle alternative that avoids this uncertainty.

## *Gentle* by design

Hydrogen peroxide diffuses through enamel and dentin into the pulp – the main cause of hypersensitivity after bleaching. Phthalimidoperoxycaproic acid (PAP), by contrast, oxidises chromogens primarily at the enamel surface, with significantly lower penetration. The result: a natural white without the typical side effects.

## Gentler than conventional bleaching, *just as effective*

Our whitening technology compared with bleaching products containing more than 6% hydrogen peroxide (H₂O₂).

### Proven results

✓

✓

### Pain-free experience without tooth sensitivity, even with damaged enamel

✓

—

### Preserves the natural tooth structure and protects enamel and dentin

✓

—

### Complies with EU cosmetics regulations

✓

—

## Results from the dental chair

With our whitening treatment, patients achieve naturally white teeth without pain.

Clinical results depend on individual factors.

### Sophia

28 Jahre

### Alessio

34 Jahre

### Ursina

64 Jahre

### Maya

41 Jahre

## *Teeth whitening* redefined

Compared with conventional in-office bleaching products containing hydrogen peroxide, AW Whitening Technology shows effective whitening of the enamel samples.

ΔE = colorimetric difference between the original and the bleached sample

Analyses of tooth samples show that the enamel is not erosively altered after treatment with AW Whitening Technology. In contrast, a product with 40% hydrogen peroxide causes structural changes to the tooth surface, altering its surface morphology.

Source: Empa, Swiss Federal Laboratories for Materials Science and Technology

A further study measured both the roughness and the surface hardness of tooth samples after treatment with bleaching products.

Roughness: On average, all four test groups showed a slight increase in roughness. A statistically significant increase compared with the untreated surface was found for a product with 40% H₂O₂, which also differed significantly from AW Whitening Technology and a product with 6% H₂O₂.

Another study measured both the roughness and the surface hardness of tooth samples after treatment with bleaching agents.

Surface hardness: Compared with intact enamel, a statistically significant drop in hardness was measured at 250 nm after treatment with a product containing 40% H₂O₂, decreasing with increasing measurement depth – i.e. the effect of the bleaching product is greater near the surface. All other products tested – including AW Whitening Technology – show negligible changes in surface microhardness relative to the standard deviation, i.e. the surface was not affected by the bleaching process.

## *Measurably brighter*, from any starting shade

Documented results from more than 1,200 treatments on the VITA shade guide: from the starting shade to the shade achieved after treatment.

- Starting shade A2: A1 reached in 83.5% of cases
- Starting shade A1: B1 reached in 80.5% of cases
- Darker starting shades (A3, A3.5): usually lightened to A2

Individual results may vary.

## Simple protocol, *easy to delegate*

The treatment protocol is simple and can be fully delegated to your practice team – to dental hygienists as well as prophylaxis assistants.

First, the reference shade of the teeth is assessed together with the patient.

The gums are covered with cotton rolls and a gingival barrier.

One gel pot is opened per application.

The whitening activator is added to the gel.

The two components are mixed.

The gel is applied to the teeth.

The gel remains on the tooth surface for the application time.

After the application cycle, the gel can be removed precisely with a suction cannula.

After repeating steps 4–9, the entire oral cavity is rinsed with water.

Finally, the gingival barrier and cotton rolls are removed.

The reference shade is determined again. The result of the whitening treatment: naturally lighter tooth shades.

## In partnership with *Coltène*

A collaboration that gives our in-office whitening a real edge. Together with Coltène, a Swiss dental manufacturer that practices already know and trust, we are bringing these innovations to market.

## Frequently asked questions about the *chair-side whitening system*

### How does a chair-side whitening treatment work?

The Chair-Side Whitening System with 13% PAP consists of a gel and a Whitening Activator. The two components are mixed directly before use. This is how the treatment works:

1. **Colour assessment:** You determine the starting tooth colour together with your patient.
2. **Gum protection:** The gums are covered with cotton rolls and a gingival barrier.
3. **Mixing and applying:** For each cycle, you open a gel pot, add the activator, mix both and apply the gel to the teeth.
4. **Exposure and suction:** The gel works for 15 minutes and is then removed with a suction cannula. You repeat this cycle four times in total.
5. **Finishing:** You rinse the oral cavity with water, remove the gingival barrier and the cotton rolls and determine the tooth colour again.

Detailed instructions for use come with the system.

### How long does a treatment take?

The treatment takes place in one session. The gel works in four cycles of 15 minutes each, so 60 minutes in total. On top of that come the colour assessment at the beginning and end, and placing and removing the gingival barrier.

No impressions, no lab work and no follow-up appointment are needed. The treatment therefore fits well into your existing appointments, for example straight after a hygiene appointment.

### Who can carry out the treatment?

The protocol is simple and can be fully delegated to your practice team. The treatment can be carried out by dentists, dental hygienists or prophylaxis assistants.

Before whitening, you check as usual that the teeth and gums are healthy. After that, your team can carry out the treatment independently, without an extra training day.

### Does the practice need special equipment or a whitening lamp?

No. You do not need a whitening lamp or any new equipment. The gel works without light.

Everything else is already in your practice: cotton rolls for gum protection, a suction cannula to remove the gel and water for rinsing. Because the protocol is so simple, you can delegate the treatment to your prophylaxis team.

### Does PAP whitening damage tooth enamel?

No. In independent laboratory tests, including at Empa (Swiss Federal Laboratories for Materials Science and Technology), the enamel showed the following after treatment with our technology:

- **Surface:** no erosive changes.
- **Roughness:** no significant increase compared with untreated enamel.
- **Surface hardness:** only negligible changes.

In the same tests, a product with 40% hydrogen peroxide changed the surface morphology, significantly increased the roughness and reduced the hardness near the surface.

The reason lies in the mode of action: PAP oxidises the colour molecules primarily at the enamel surface and penetrates much less deeply. The technology has also been studied by the Fraunhofer Institute.

### How does the result compare with high-strength hydrogen peroxide?

With PAP, your patients achieve a natural white. In laboratory tests, our technology effectively whitened enamel samples, compared with conventional in-office products with hydrogen peroxide.

The difference lies in how they work:

- **High-strength hydrogen peroxide** penetrates through enamel and dentin to near the pulp. This allows very strong whitening, but often leads to temporary hypersensitivity.
- **PAP** works primarily at the enamel surface. Sensitivity therefore occurs much less often.

For very deep, stubborn stains, hydrogen peroxide can be the stronger option. For this, we offer our Whitening Trays with 6% hydrogen peroxide for use at home.

### Is the Professional range legally compliant?

Yes. Our entire Professional range meets the current cosmetics regulations in the EU and Switzerland.

- **PAP products:** They comply with the EU Cosmetics Regulation. After examination and consultation, you can hand them directly to your patients.
- **6% hydrogen peroxide:** Products with more than 0.1% and up to 6% hydrogen peroxide may only be supplied to dentists. A dental examination is required before they are supplied, and the first application takes place in the practice. Use is not permitted for people under 18.

That is why we check with every registration that it is a dental practice.

### How do I see prices and where can I order?

You can see the wholesale prices as soon as your practice is registered and activated. Simply log in to your account.

You can order in two ways:

- **Directly from us:** at wholesale prices, with easy reordering and payment by invoice.
- **Through your dental supplier:** Our products are available from many dental suppliers across Europe. If your supplier does not stock a product yet, order it directly from us or contact us. We will then make sure it is added to their range.

## Whitening stays *in your practice*

Gentle, effective and already in demand among your patients. Register your practice for wholesale prices.

---
Canonical: https://www.alpinewhite.com/en-EU/pro/in-office-whitening
